IEEE488 card

National Instruments

GPIB-USB-HS

Starter System Setup

www.ti.com

Figure 19 shows how to connect the IEEE488 to the DMM. The software for the Multi-Cal-System requires

the National Instruments GPIB-USB-HS. This option is also used for remote control of the instrument. In

order to use this capability, you must set the DMM to IEEE488 mode, and set the address according to

the control script (default = 3). An optional way to communicate with the DMM is through the RS-232 port

on your computer.

Figure 19. Connect IEEE488 to DMM

20

Multi-Cal-System Evaluation Module

SBOU087A

– August 2010 – Revised April 2011

Submit Documentation Feedback

Copyright

© 2010–2011, Texas Instruments Incorporated