Multi-Cal-Slave PCA

Multi-Cal-Master PCA

Cable is keyed to

mate with connector

on bottom of Slave PCA

Notch in connector

on bottom of Slave PCA

Expanding the System Size

www.ti.com

Now connect the slave ribbon cable to the slave. Make sure to match the key on the ribbon cable with the

notch in the connector, as Figure 25 shows. Note that the cable loop is outside of the master and slave

boards.

Figure 25. Connect Slave Ribbon Cable to Slave

24

Multi-Cal-System Evaluation Module

SBOU087A

– August 2010 – Revised April 2011

Submit Documentation Feedback

Copyright

© 2010–2011, Texas Instruments Incorporated