| Electronic Components Datasheet Search |
|
WM8903CLGEFK/R Datasheet(PDF) 75 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8903CLGEFK/R Datasheet(HTML) 75 Page - Wolfson Microelectronics plc |
|
75 / 178 page ![]() Production Data WM8903 w PD, Rev 4.5, June 2012 75 ANALOGUE OUTPUTS The WM8903 has eight analogue output pins: Headphone outputs, HPOUTL and HPOUTR Line outputs, LINEOUTL and LINEOUTR Differential line outputs, LON/LOP and RON/ROP The output signal paths and associated control registers are illustrated in Figure 33. HEADPHONE OUTPUTS – HPOUTL AND HPOUTR The headphone outputs are designed to drive 16Ω or 32Ω headphones. These outputs are ground- referenced, i.e. no series capacitor is required between the pins and the headphone load. They are powered by an on-chip charge pump (see “Charge Pump” section). Signal volume at the headphone outputs is controlled as shown in Table 46. The ground-referenced outputs incorporates a common mode, or ground loop, feedback path which provides rejection of system-related ground noise. The return path for the HPOUTL and HPOUTR outputs is via HPGND. This pin must be connected to ground for normal operation of the headphone output. No register configuration is required. LINE OUTPUTS – LINEOUTL AND LINEOUTR The line outputs are identical to the headphone outputs in design. They are ground-referenced and power by the on-chip charge pump. Signal volume at the headphone outputs is controlled as shown in Table 47. Note that these outputs are intended for driving line loads, as the charge pump powering both the Headphone and Line outputs can only provide sufficient power to drive one set of headphones at any given time. The ground-referenced outputs incorporates a common mode, or ground loop, feedback path which provides rejection of system-related ground noise. The return path for the LINEOUTL and LINEOUTR outputs is via LINEGND. This pin must be connected to ground for normal operation of the line output. No register configuration is required. DIFFERENTIAL LINE OUTPUTS – LON/LOP AND RON/ROP The differential line outputs are designed to differential line loads, including external loudspeaker drivers. The WM9001 is an ideal component for driving loudspeakers from these outputs. These pins are referenced to VMID (AVDD/2) and are powered directly from the AVDD supply. Signal volume at the differential line outputs is controlled as shown in Table 48. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |