LP064V1 LIQUID CRYSTAL DISPLAY

SPECIFICATIONS

TITLE: LP064V1 REV. 1 PAGE 17 OF 17

DATA DISPLAY AG

Industriestrasse 1

D-82110 Germering

DEZ 1999

http://www.datadisplay.de

Tel.: +49-89-894450-0

Fax: +49-89-894450-90

13.2 OPERATING PRECAUTION

• The spike noise causes the mis-operation of circuits. Be lower the spike noise as

• Response time depends on the temperature (in lower temperature, it becomes

longer).

• Brightness depends on the temperature (in lower temperature, it becomes lower).

In lower temperature, response time (required time that brightness is stable after

turn on) becomes longer.

• Be careful for condensation at suddern temperature change. Condensation make

damage to polarizer or electrical contact part. And after fading condensation,

smear or spot will occur.

• When fixed pattern are displayed at long times, remnant image is likely to occur.

• Module has high frequency circuit. If you need to shield the electromagnetic

noise, please do in yours.

• When Back-light unit is operating, it sounds. If you need to shield the noise,

please do in yours.

13.3 ELECTROSTATIC DISCHARGE CONTROL

Since module is composed with electronic circuit, it is not strong to electrostatic

discharge. Make certain that treatment persons are connected to ground through list

band etc.. Please do not touch I/F pin directly.

13.4 PRECAUTION FOR STRONG LIGHT EXPOSURE.

Strong light exposure causes degradation of polarizer and color filter.

13.5 STORAGE

When storing module as spares for long time, the following precautions are

necessary.

• Store them in a dark place: do not expose then to sunlight or fluorescent light.

Keep the temperature between 5° and 35° at normal humidity.

• The polarizer surface should not come in contact with any other object. It is

recommended that they be stored in the container in which they were shipped.

13.6 HANDLING PRECAUTIONS FOR PROTECTION FILM

• When the protection film is pealed off, static electricity is generated between the

film and the polarizer. This film should be pealed off slowly and carefully by

people who are electrically grounded and with well ion-blown equipment or in

such a condition. etc.

• The protection film is attached the polarizer with a small amount of glue.If some

stress is applied to rub the protection film against the polarizer during the time

you peal off the film, the glue is apt to remain more on the polarizer. So please

carefully peal off the protection film without rubbing it against the polarizer.