ST72361AR4-Auto datasheet(261/279 Pages) STMICROELECTRONICS

261 / 279 page

ST72361xx-Auto

Device configuration and ordering information

Doc ID 12468 Rev 3

261/279

Caution:

The PLL can be enabled only if the “OSC RANGE” (OPT11:10) bits are configured to “MP -

2~4 MHz”. Otherwise, the device functionality is not guaranteed.

OPT2:1 = PKG[1:0] Package selection

These option bits select the device package.

Note:

Pads that are not bonded to external pins are in input pull-up configuration when the

package selection option bits have been properly programmed. The configuration of these

pads must be kept in reset state to avoid added current consumption.

OPT0 = FMP_R Flash memory read-out protection

Read-out protection, when selected provides a protection against program memory content

extraction and against write access to Flash memory. Erasing the option bytes when the

FMP_R option is selected causes the whole user memory to be erased first, and the device

can be reprogrammed. Refer to Section 3.3.1: Read-out protection and the ST7 Flash

Programming Reference Manual for more details.

0: read-out protection enabled

1: read-out protection disabled

Option byte 1

OPT7:6 = AFI_MAP[1:0] AFI Mapping

These option bits allow the mapping of some of the Alternate Functions to be changed.

Static option byte 0

Static option byte 1

WDG

LVD

PKG

AFI_MAP

OSCTYPE

OSCRANGE

Default(1)

Option bit values programmed by ST.

111

Table 115.

Package selection

Selected package

PKG

LQFP 64

LQFP 44

LQFP 32

ST72361AR4-Auto Datasheet(PDF) 261 Page - STMicroelectronics

ST72361AR4-Auto Datasheet(HTML) 261 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL