ST72361AR4-Auto datasheet(262/279 Pages) STMICROELECTRONICS

262 / 279 page

Device configuration and ordering information

ST72361xx-Auto

262/279

Doc ID 12468 Rev 3

OPT5:4 = OSCTYPE[1:0] Oscillator Type

These option bits select the ST7 main clock source type.

OPT3:2 = OSCRANGE[1:0] Oscillator range

If the resonator oscillator type is selected, these option bits select the resonator oscillator.

This selection corresponds to the frequency range of the resonator used. If external source

is selected with the OSCTYPE option, then the OSCRANGE option must be selected with

the corresponding range.

Table 116.

Alternate function remapping 1

AFI mapping 1

AFI_MAP(1)

T16_OCMP1 on PD3

T16_OCMP2 on PD5

T16_ICAP1 on PD4

LINSCI2_SCK not available

LINSCI2_TDO not available

LINSCI2_RDI not available

T16_OCMP1 on PB6

T16_OCMP2 on PB7

T16_ICAP1 on PC0

LINSCI2_SCK on PD3

LINSCI2_TDO on PD5

LINSCI2_RDI on PD4

Table 117.

Alternate function remapping 0

AFI mapping 0

AFI_MAP(0)

T16_ICAP2 is mapped on PD1

T16_ICAP2 is mapped on PC1

Table 118.

OSCTYPE selection

Clock source

OSCTYPE

Resonator oscillator

Reserved

Reserved internal clock source (used only in ICC mode)

External source

Table 119.

OSCRANGE selection

Typical frequency range

OSCRANGE

1~2 MHz

2~4 MHz

ST72361AR4-Auto Datasheet(PDF) 262 Page - STMicroelectronics

ST72361AR4-Auto Datasheet(HTML) 262 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL