STM32F378VC datasheet(70/131 Pages) STMICROELECTRONICS

70 / 131 page

Electrical characteristics

STM32F378xx

70/131

DocID025608 Rev 4

6.3.5

Wakeup time from low-power mode

The wakeup times given in Table 44 are measured from the wakeup event trigger to the first

instruction executed by the CPU. The clock source used to wake up the device depends

from the current operating mode:

•

Stop or sleep mode: the wakeup event is WFE.

•

The WKUP1 (PA0) pin is used to wakeup from stop and sleep modes.

All timings are derived from tests performed under ambient temperature and VDD supply

voltage conditions summarized in Table 22.

APB1 peripherals

µA/MHz

APB1-Bridge(3)

6.9

TIM2

47.9

TIM3

36.8

TIM4

36.9

TIM5

45.5

TIM6

8.4

TIM7

8.2

TIM12

21.3

TIM13

14.2

TIM14

14.4

TIM18

10.1

WWDG

4.7

SPI2

24.3

SPI3

25.3

USART2

45.3

USART3

43.1

I2C1

14.0

I2C2

13.9

CAN

38.1

DAC2

7.7

PWR

5.4

DAC1

14.8

CEC

5.4

1. When peripherals are enabled, power consumption of the analog part of peripherals such as ADC, DACs,

Comparators, etc. is not included. Refer to those peripherals characteristics in the subsequent sections.

2. The BusMatrix is automatically active when at least one master is ON (CPU, DMA1 or DMA2).

3. The APBx Bridge is automatically active when at least one peripheral is ON on the same Bus.

Table 34. Peripheral current consumption (continued)

Peripheral

Typical consumption(1)

Unit

STM32F378VC Datasheet(PDF) 70 Page - STMicroelectronics

STM32F378VC Datasheet(HTML) 70 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL