P89LPC913FDH datasheet(34/63 Pages) PHILIPS

34 / 63 page

Philips Semiconductors

P89LPC912/913/914

8-bit microcontrollers with two-clock 80C51 core

Product data

Rev. 03 — 17 December 2004

34 of 63

9397 750 14468

9.11.7

Additional port features

After power-up, all pins are in Input-Only mode. After power-up all I/O pins except

P1.5, may be conﬁgured by software.

• Pin P1.5 is input only.

• P1.2/T0 is conﬁgurable for either input-only or open-drain (P89LPC912,

P89LPC914).

Every output on the P89LPC912/913/914 has been designed to sink typical LED

drive current. However, there is a maximum total output current for all ports which

must not be exceeded. Please refer to Table 13 “DC electrical characteristics” for

detailed speciﬁcations.

All port pins that can function as an output have slew rate controlled outputs to limit

noise generated by quickly switching output signals. The slew rate is factory-set to

approximately 10 ns rise and fall times.

9.12 Power monitoring functions

The P89LPC912/913/914 incorporates power monitoring functions designed to

prevent incorrect operation during initial power-up and power loss or reduction during

operation. This is accomplished with two hardware functions: Power-on Detect and

Brownout detect.

9.12.1

Brownout detection

The Brownout detect function determines if the power supply voltage drops below a

certain level. The default operation is for a Brownout detection to cause a processor

reset, however, it may alternatively be conﬁgured to generate an interrupt.

Brownout detection may be enabled or disabled in software.

If Brownout detection is enabled, the brownout condition occurs when VDD falls below

the brownout trip voltage, VBO (see Table 13 “DC electrical characteristics”), and is

negated when VDD rises above VBO. If the P89LPC912/913/914 device is to operate

with a power supply that can be below 2.7 V, BOE should be left in the

unprogrammed state so that the device can operate at 2.4 V, otherwise continuous

brownout reset may prevent the device from operating.

For correct activation of Brownout detect, the VDD rise and fall times must be

observed. Please see Table 13 “DC electrical characteristics” for speciﬁcations.

9.12.2

Power-on detection

The Power-on Detect has a function similar to the Brownout detect, but is designed to

work as power comes up initially, before the power supply voltage reaches a level

where Brownout detect can work. The POF ﬂag in the RSTSRC register is set to

indicate an initial power-up condition. The POF ﬂag will remain set until cleared by

software.

9.13 Power reduction modes

The P89LPC912/913/914 supports three different power reduction modes. These

modes are Idle mode, Power-down mode, and total Power-down mode.

P89LPC913FDH Datasheet(PDF) 34 Page - NXP Semiconductors

P89LPC913FDH Datasheet(HTML) 34 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Datasheet Download

Link URL