ISO6720_V02 datasheet(30/49 Pages) TI

30 / 49 page

9.2.3 Application Curve

The following typical eye diagrams of the ISO672xB family of devices indicate low jitter and wide open eye at the

maximum data rate of 50 Mbps.

Time = 5 ns / div

Figure 9-3. Eye Diagram at 50 Mbps PRBS 216 – 1,

5 V and 25°C

Time = 5 ns / div

Figure 9-4. Eye Diagram at 50 Mbps PRBS 216 – 1,

3.3 V and 25°C

Time = 5 ns / div

Figure 9-5. Eye Diagram at 50 Mbps PRBS 216 – 1,

2.5 V and 25°C

Time = 5 ns / div

Figure 9-6. Eye Diagram at 50 Mbps PRBS 216 – 1,

1.8 V and 25°C

9.2.3.1 Insulation Lifetime

Insulation lifetime projection data is collected by using industry-standard Time Dependent Dielectric Breakdown

(TDDB) test method. In this test, all pins on each side of the barrier are tied together creating a two-terminal

device and high voltage applied between the two sides; See Figure 9-7 for TDDB test setup. The insulation

breakdown data is collected at various high voltages switching at 60 Hz over temperature. For basic insulation,

VDE standard requires the use of TDDB projection line with failure rate of less than 1000 part per million (ppm).

For reinforced insulation, VDE standard requires the use of TDDB projection line with failure rate of less than 1

part per million (ppm).

Even though the expected minimum insulation lifetime is 20 years, at the specified working isolation voltage,

VDE basic and reinforced certifications require additional safety margin of 20% for working voltage. For basic

certification, device lifetime requires a safety margin of 30% translating to a minimum required insulation lifetime

of 26 years at a working voltage that is 20% higher than the specified value.

Figure 9-8 shows the intrinsic capability of the isolation barrier to withstand high voltage stress over its lifetime.

Based on the TDDB data, the intrinsic capability of the insulation is 450 VRMS with a lifetime of >100 years in

the 8D package . Other factors, such as package size, pollution degree, material group, etc. can further limit the

working voltage of the component. At the lower working voltages, the corresponding insulation lifetime is much

longer than 100 years in the 8-D package.

ISO6720, ISO6721, ISO6721R

SLLSFJ0D – JANUARY 2020 – REVISED SEPTEMBER 2021

www.ti.com

Submit Document Feedback

Product Folder Links: ISO6720 ISO6721 ISO6721R

ISO6720 Datasheet(PDF) 30 Page - Texas Instruments