F39-TGR-CVL-B-2-R datasheet(95/98 Pages) OMRON

95 / 98 page

SECTION 18

Appendix

18-1 Appendix A

Checkout procedure log

The following checkout procedure must be performed by qualified personnel

during initial MS4800 system installation and at least every three months or

more frequently depending on machine usage and company guidelines.

Machine identification____________________________ Date____________

Technician Signature ___________________________________________

Item

Condition

Comments

Verify that the guarded machine is compatible with

the type of machine which may be used with the

MS4800 system. See the chapter - "Precautions on

Safety" for further information.

@ Pass

@ Fail

Verify that the mounting distance of the MS4800 sys-

tem is equal to or greater than the minimum safe dis-

tance from the danger point. See the chapter "Safe

mounting distance" for further information.

@ Pass

@ Fail

Determine that all access to the danger point not pro-

tected by the MS4800 system is guarded by other

means, such as gates, fencing or other approved

methods. Verify that all additional guarding devices

are installed and operating properly.

@ Pass

@ Fail

Make sure the operator is not able to stand between

the MS4800 system detection zone and the machine

danger point. Verify that the light curtain can only be

reset from a position outside and within view of the

hazardous machine area.

@ Pass

@ Fail

Inspect the electrical connections between the

guarded machine's control system and the MS4800

system. Verify that they are properly connected to

the machine such that a stop signal from the

MS4800 system results in an immediate halt of the

machine's cycle. See the chapter "Connecting to the

machine control circuit" for further information.

@ Pass

@ Fail

If the EDM monitoring feature is not used, proceed to

the next step. To test the EDM feature, verify that the

feature has been enabled. Turn the machine power

on. Cycle the machine. Place a temporary jumper

wire between the EDM connections. The MS4800

should enter an alarm condition. Remove the tempo-

rary jumper. Press and release the start button.

@ Pass

@ Fail

Record the test results in the machine log, then per-

form the test procedure.

@ Pass

@ Fail

F39-TGR-CVL-B-2-R Datasheet(PDF) 95 Page - Omron Electronics LLC

F39-TGR-CVL-B-2-R Datasheet(HTML) 95 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98

Datasheet Download

Link URL