F39-TGR-CVL-B-2-R datasheet(19/98 Pages) OMRON

19 / 98 page

SECTION 1

Important Safety Warnings

!WARNING Read and understand this section prior to installing an MS4800 system.

An MS4800 system is a general purpose sensing device designed to guard

personnel working around moving machinery.

Whether a specific machine application and MS4800 system installation com-

plies with safety regulations depends on the proper application, installation,

maintenance and operation of the MS4800 system. These items are the

responsibility of the purchaser, installer and employer.

The employer is responsible for the selection and training of personnel to

properly install, operate and maintain the machine and its safeguarding sys-

tems. An MS4800 system should only be installed verified and maintained by

a qualified person. A qualified person is defined as "an individual who under-

stands, is trained on, and demonstrates competence with the construction,

operation or maintenance of the machinery and the hazards involved."

To use the MS4800 system the following requirements must be met:

• The national/international rules and regulations apply to the installation,

use and periodic technical inspections of the safety light curtain, in partic-

ular:

• Machine Directive (98/37/EC) and (2006/42/EC)

• Equipment Usage Directive (89/655/EC)

• The work safety regulations/safety rules

• Other relevant health and safety regulations

• Observe the instructions in this manual regarding test regulations (e.g. on

use, mounting, installation or integration into the existing machine control

system) carefully.

• The tests must be carried out by specialist personnel or specially qualified

and authorized personnel and must be recorded and documented to

ensure that the tests can be reconstructed and retraced at any time.

• Check the effectiveness of the protective device after every change

because a change may degrade the safety function.

• The operating instructions must be made available to the operator of the

machine where the MS4800 system is installed.

• The machine operator is to be instructed in the use of the device by spe-

cialist personnel and must be instructed to read the operating instructions.

• The guarded machine must not present a hazard from flying parts.

• The guarded machine must have a consistent stopping time and ade-

quate control mechanisms.

• Additional guarding may be required for access to dangerous areas not

covered by the MS4800 system.

Protection of the environment

This product has been designed to minimize environmental impact. For this

reason please note that disposal of irreparable/unserviceable devices has to

be in compliance with your local/national rules and regulations. Please con-

tact your local OMRON sales representative for assistance.

F39-TGR-CVL-B-2-R Datasheet(PDF) 19 Page - Omron Electronics LLC

F39-TGR-CVL-B-2-R Datasheet(HTML) 19 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98

Datasheet Download

Link URL