HC705RC16GRSSLASHD datasheet(79/120 Pages) NXP

79 / 120 page

Carrier Modulator Transmitter (CMT)

Modulator

MC68HC705RC16 — Rev. 3.0

General Release Specification

Carrier Modulator Transmitter (CMT)

EIMSK — External Interrupt Mask

The external interrupt mask bit is used to mask IRQ and keyscan

interrupts. This bit is cleared by reset.

1 = IRQ and keyscan interrupts masked

0 = IRQ and keyscan interrupts enabled

EXSPC — Extended Space Enable

For a description of the extended space enable bit, see 9.5.3

Extended Space Operation. This bit is cleared by reset.

1 = Extended space enabled

0 = Extended space disabled

BASE — Baseband Enable

When set, the BASE bit disables the carrier generator and forces the

carrier output high for generation of baseband protocols. When BASE

is clear, the carrier generator is enabled and the carrier output toggles

at the frequency determined by values stored in the carrier data

registers. See 9.5.1 Time Mode. This bit is cleared by reset. This bit

is not double buffered and should not be written to during a

transmission.

1 = Baseband enabled

0 = Baseband disabled

MODE — Mode Select

For a description of CMT operation in time mode, see 9.5.1 Time

Mode. For a description of CMT operation in FSK mode, see 9.5.2

FSK Mode. This bit is cleared by reset. This bit is not double buffered

and should not be written to during a transmission.

1 = CMT operates in FSK mode.

0 = CMT operates in time mode.

IE — Interrupt Enable

A CPU interrupt will be requested when EOC is set if IE was

previously set. If IE is clear, EOC will not request a CPU interrupt.

1 = CPU interrupt enabled

0 = CPU interrupt disabled

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705RC16GRS/D Datasheet(PDF) 79 Page - NXP Semiconductors