S12SCIV3SLASHD datasheet(31/98 Pages) NXP

31 / 98 page

MC9S12KG128 SoC Guide — V01.01

2.3.10 PE7 / NOACC / XCLKS — Port E I/O Pin 7

PE7 is a general purpose input or output pin. During MCU expanded modes of operation, the NOACC

signal, when enabled, is used to indicate that the current bus cycle is an unused or “free” cycle. This signal

will assert when the CPU is not using the bus.

The XCLKS is an input signal which controls whether a crystal in combination with the internal Loop

Controlled Pierce (low power) oscillator is used or whether Full Swing Pierce oscillator/external clock

circuitry is used. The state of this pin is latched at the rising edge of RESET. If the input is a logic low the

EXTAL pin is configured for an external clock drive or Full Swing Pierce Oscillator. If input is a logic

high a Loop Controlled Pierce oscillator circuit is configured on EXTAL and XTAL. Since this pin is an

input with a pull-up device during reset, if the pin is left floating, the default configuration is a Loop

Controlled Pierce oscillator circuit on EXTAL and XTAL.

Figure 2-4 Loop Controlled Pierce Oscillator Connections (XCLKS=1)

Figure 2-5 Full Swing Pierce Oscillator Connections (XCLKS=0)

Table 2-3 Clock selection based on XCLKS during reset

XCLKS

Description

Loop Controlled Pierce Oscillator selected

Full Swing Pierce Oscillator or external clock selected

MCU

EXTAL

XTAL

VSSPLL

Crystal or

ceramic resonator

* Rs can be zero (shorted) when use with higher frequency crystals.

Refer to manufacturer’s data.

MCU

EXTAL

XTAL

VSSPLL

Crystal or

ceramic resonator

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

S12SCIV3/D Datasheet(PDF) 31 Page - NXP Semiconductors