EMC646SP16JS-90L datasheet(10/65 Pages) EMLSI

10 / 65 page

EMC646SP16J

4Mx16 CellularRAM

Preliminary

Bus Operating Modes

64M CelluarRAM products incorporate a burst mode interface found on Flash products targeting low-power, wireless applications. This

bus interface supports asynchronous, page mode, and burst mode read and write transfers. The specific interface supported is defined

by the value loaded into the BCR. Page mode is controlled by the refresh configuration register (RCR[7]).

Asynchronous Mode

CellularRAM products power up in the asynchronous operating mode.This mode uses the industry- standard SRAM control bus (CE#,

OE#, WE#, and LB#/UB#). READ operations (Figure 3) are initiated by bringing CE#, OE#, and LB#/UB# LOW while keeping WE#

HIGH. Valid data will be driven out of the I/Os after the specified access time has elapsed. WRITE operations (Figure 4) occur when

CE#, WE#, and LB#/UB# are driven LOW. During asychronous WRITE operations, the OE# level is a “Don’t care”, and WE# will over-

ride OE#. The data to be written is latched on the rising edge of CE#, WE#, or LB#/UB# (whichever occurs first). Asychronous opera-

tions (page mode disabled) can either use the ADV# input to latch the address, or ADV# can be driven LOW during the entire READ/

WRITE operation.

During asychronous operation, the CLK input must be held static LOW. WAIT will be driven while the device is enabled and its state

should be ignored. WE# LOW time must be limited to tCEM

Figure 3: READ Operation (ADV# LOW)

Note: ADV# must remain Low for PAGE MODE operation.

High-Z

Don’t Care

CE#

Address

OE#

LB#/UB#

DATA

tRC = READ Cycle Time

Data Valid

Address Valid

WE#

EMC646SP16JS-90L Datasheet(PDF) 10 Page - Emerging Memory & Logic Solutions Inc