SA9101 datasheet(15/40 Pages) SAMES

15 / 40 page

SA9101

sames

15/40

i bits: reserved for international use.

If not used, these bits should be

fixed to ‘1’. Access to received information via bits SR4B7 and SR5B2.

Transmission is enabled via bits CR4B7 and CR5B2.

Fixed to ‘1’. Used for synchronization.

Remote Alarm Indication: In normal operation ‘0’; in alarm condition ’1'.

Transmission is done through CR4B5 and reception is indicated by interrupt

(maskable) and SR0B4.

n (Y) bits: Reserved for national use. If not used, they should be fixed at

‘1’. Access to received information via bits SR4B[4-0]. Transmission is

enabled via bits CR4B[4-0]

Synchronization procedure

Synchronization status is reported via µP-interface Status Register. Framing errors are

counted by the Framing Error Counter. Loss of synchronization is reached after detecting

3 consecutive incorrect FAS words or 3 consecutive incorrect service words (bit 2

≠ 1 in

timeslot 0 of every frame not containing the frame alignment word). When this occurs,

counting of framing errors will be stopped and AIS will be sent to the system internal

highway.

The re-synchronization procedure starts automatically after entering loss of synchronisation

state. Additionally, it may be invoked under user control via the µP-interface.

Synchronized state is reached after detecting:

a correct FAS word in frame n,

the presence of the correct service word (bit 2 = 1) in frame n+1

a correct FAS word in frame n+2

Normal Synchronized operation starts with the data in frame n+2.

CRC-Multiframe

The multiframe structure shown in table 2 is enabled via µP-interface.

Multiframe

2 submultiframes = 2*8 frames

Multiframe alignment

bit 1 of frames 1,3,5,7,9,11 with the pattern ‘001011’

CRC bits

bit 1 of frames 0,2,4,6,8,10,12,14

CRC block size

2048 bit (length of a submultiframe)

CRC procedure

CRC4, according to CCITT Rec. G704

The CRC procedure is automatically invoked when the multiframe structure is enabled.

CRC errors in the received data stream are counted by the CRC Error Counter (max. one

error per sub-multiframe). This 8-bit counter is extendable to 10 bit length.

SA9101 Datasheet(PDF) 15 Page - Sames

SA9101 Datasheet(HTML) 15 Page - Sames

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Download

Link URL