EM357-MOD-RF-T datasheet(23/43 Pages) SILABS

23 / 43 page

4-3

EM35x Development Kit User Guide

120-4030-000E

4.5

Breakout Board Power Configurations

The Breakout Board may be powered in one of four ways:

•

Breakout Board Power Supplied by ISA3 (Figure 4-2): The default configuration is to supply power via

the InSight Adapter and InSight Port cable. Ensure the power switch on the InSight Adapter is in the

INT (Internal) position. The power supply of the InSight Adapter is also controlled via the admin

interface. You may need to connect to the admin port of the ISA and issue the “power on” command.

No external power supply should be connected to the Breakout Board when supplying power from the

ISA. The power supply jumper on the Breakout Board should be in the horizontal position, connecting

V_ISA to the center pin. The V_ISA LED will illuminate when power is applied.

Figure 4-2. Breakout Board Power Supplied by ISA3

•

Breakout Board Power Supplied by USB (Figure 4-3): The Breakout Board may also be powered via the

USB connector, either using a USB cable plugged in to the USB power adapter included in the

development kit, or by connecting it to your PC. The power supply jumper on the Breakout Board

should be in the lower vertical position, connecting V_REG to the center pin. The V_USB LED will

illuminate when power is applied. When powering the Breakout Board in this way, ensure the power

switch on the InSight Adapter is in the EXT (External) position.

EM357-MOD-RF-T Datasheet(PDF) 23 Page - Silicon Laboratories