EM78P451SWM datasheet(41/54 Pages) EMC

41 / 54 page

EM78P451S

8-Bit Microcontroller with OTP ROM

Product Specification (V1.0) 06.01.2004

• 37

(This specification is subject to change without further notice)

Table 9 The Status of RST, T and P Being Affected by Events

Event

Power on

WDTC instruction

WDT time-out

SLEP instruction

Wake-Up on pin change during SLEEP2 mode

* P: Previous value before reset

4.8 Interrupt

The EM78P451S has the following interrupts.

1. /TCC overflow interrupt

2. External interrupt (/INT)

3. Serial Peripheral Interface (SPI) transmission completed interrupt.

4. Timer1 comparator completed interrupt.

R3F is the interrupt status register, which records the interrupt request in flag bit. IOCF

is the interrupt mask register. Global interrupt is enabled by ENI instruction and is

disabled by DISI instruction. When one of the interrupts (if enabled) is generated, will

cause the next instruction to be fetched from address 001H. Once in the interrupt

service routine the source of the interrupt can be determined by polling the flag bits in

the R3F register. The interrupt flag bit must be cleared by software before leaving the

interrupt service routine and enabling interrupts to avoid recursive interrupts.

The flag in the Interrupt Status Register (R3F) is set regardless of the status of its mask

bit or the execution of ENI instruction. Note that reading R3F will obtain the output of

logic AND of R3F and IOCF (refer to Fig. 17). The RETI instruction exits interrupt

routine and enables the global interrupt (execution of ENI instruction).

When an interrupt is generated by INT instruction (if enabled), it causes the next

instruction to be fetched from address 002H.

EM78P451SWM Datasheet(PDF) 41 Page - ELAN Microelectronics Corp