H8SLASH3002 datasheet(102/700 Pages) RENESAS

102 / 700 page

5.3 Interrupt Sources

The interrupt sources include external interrupts (NMI, IRQ0 to IRQ5) and 30 internal interrupts.

5.3.1 External Interrupts

There are seven external interrupts: NMI, and IRQ0 to IRQ5. Of these, NMI, IRQ0, IRQ1, and

IRQ2 can be used to exit software standby mode.

NMI: NMI is the highest-priority interrupt and is always accepted, regardless of the states of the

I and UI bits in CCR. The NMIEG bit in SYSCR selects whether an interrupt is requested by the

rising or falling edge of the input at the NMI pin. NMI interrupt exception handling has vector

number 7.

IRQ0 to IRQ5 Interrupts: These interrupts are requested by input signals at pins IRQ0 to IRQ5.

The IRQ0 to IRQ5 interrupts have the following features.

•

ISCR settings can select whether an interrupt is requested by the low level of the input at pins

IRQ0 to IRQ5, or by the falling edge.

•

IER settings can enable or disable the IRQ0 to IRQ5 interrupts. Interrupt priority levels can be

assigned by four bits in IPRA (IPRA7 to IPRA4).

•

The status of IRQ0 to IRQ5 interrupt requests is indicated in ISR. The ISR flags can be

cleared to 0 by software.

Figure 5-2 shows a block diagram of interrupts IRQ0 to IRQ5.

Figure 5-2 Block Diagram of Interrupts IRQ0 to IRQ5

input

Edge/level

sense circuit

IRQnSC

IRQnF

IRQnE

IRQn interrupt

request

Clear signal

IRQn

Note: n = 5 to 0

H8/3002 Datasheet(PDF) 102 Page - Renesas Technology Corp