| Electronic Components Datasheet Search |
|
705-5100-F21 Datasheet(PDF) 15 Page - Magnetrol International, Inc. |
|
|
|||||||||||||||||||||||||||||
705-5100-F21 Datasheet(HTML) 15 Page - Magnetrol International, Inc. |
|
15 / 52 page ![]() 15 57-645 Eclipse Guided Wave Radar Transmitter - PROFIBUS PA™ 3.4.2.2 To install a Model 7x7 standard flexible twin rod probe: x Make sure the process connection is at least 2" NPT or a flanged mounting. y Make sure that there is at least 1" (25 mm) spacing between the active probe rod and any part of the tank (walls, still- well, pipes, support beams, mixer blades, etc.). Minimum stillwell diameter for Twin Rod probe is 3". z Carefully place the probe into the vessel. Align the gasket on flanged installations. { Align the probe process connection with the threaded or flanged mounting on the vessel. | For threaded connections, tighten the hex nut of the probe process connection. For flanged connections, tighten flange bolts. Probe can be shortened in the field: } a. Raise the weight (1) to expose the two securing devices (2). b. Loosen the two #10-32 set screws (3) on both securing devices using a 3⁄32" (2.5 mm) hex wrench and slide the securing devices off of the probe. c. Slide the TFE weight off of the probe. d. Cut and remove the required cable (4) length. e. Remove 31⁄2" of the rib between the two cables. f. Strip 5⁄8" (16 mm) of coating from the two cables. g. Slide the TFE weight back on to the probe. h. Reattach securing device and tighten screws. i. Enter new probe length (inches or cm) in software. 3.4.3 Installing a Single Rod Probe (Models 7x1, 7x2, 7xF, 7xJ) Before installing, make sure the: • Model and serial numbers on the nameplates of the Eclipse probe and transmitter are identical. • Probe has adequate headroom for installation and has unob- structed entry to the bottom of the vessel. • Process temperature, pressure, dielectric, viscosity, and media buildup are within the probe specifications for the installation. • Nozzle does not restrict performance by ensuring the following: 1. Nozzle is <2" (50mm) diameter. 0.50" (13 mm) Ø 1 3 2 4 x y z {| } } |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |