AN4228 datasheet(34/90 Pages) STMICROELECTRONICS

34 / 90 page

Peripheral migration

AN4228

34/90

DocID024110 Rev 5

3.15

USART interface

The STM32F3 series embeds a new USART peripheral versus the STM32F1 series. The

architecture, features and programming interface are modified to introduce new capabilities.

As a consequence, the STM32F3 series USART programming procedures and registers are

modified from those of the STM32F1 series, so any code written for the STM32F1 series

using the USART needs to be updated to run on STM32F3 series.

The STM32F3 series USART provides best-in-class added features:



A choice of independent clock sources allowing

–

UART functionality and wake-up from low power modes,

–

convenient baud-rate programming independently of the APB clock

reprogramming.



SmartCard emulation capability: T=0 with auto retry and T=1



Swappable Tx/Rx pin configuration



Binary data inversion



Tx/Rx pin active level inversion



Transmit/receive enable acknowledge flags



New Interrupt sources with flags:

–

Address/character match

–

Block length detection and timeout detection



Timeout feature



Modbus communication



Overrun flag disable



DMA disable on reception error



Wake-up from STOP mode



Auto baud rate detection capability



Driver Enable signal (DE) for RS485 mode

For more information about STM32F3 USART features, please refer to USART chapter in

the corresponding Reference Manual.

AN4228 Datasheet(PDF) 34 Page - STMicroelectronics

AN4228 Datasheet(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

Datasheet Download

Link URL