| Electronic Components Datasheet Search |
|
T83C5121 Datasheet(PDF) 46 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
T83C5121 Datasheet(HTML) 46 Page - ATMEL Corporation |
|
46 / 110 page ![]() 46 T8xC5121 4164E–SCR–02/04 A low-priority interrupt can be interrupted by a high priority interrupt, but not by another low-priority interrupt. A high-priority interrupt can’t be interrupted by any other interrupt source. If two interrupt requests of different priority levels are received simultaneously, the request of higher priority level is serviced. If interrupt requests of the same priority level are received simultaneously, an internal polling sequence determines which request is serviced. Thus within each priority level there is a second priority structure determined by the polling sequence. Table 31. Interrupt Vector Addresses INT1 Interrupt Vector The INT1 interrupt is multiplexed with the three following inputs: •INT1/OE: Standard 8051 interrupt input • Rxd: Received data on UART • CPRES: Insertion or removall of the main card The setting configurations for each input is detailed below: INT1/OE Input This interrupt input is active under the following conditions: • It must be enabled thanks to OEEN Bit (ISEL Register) • It can be active on a level or falling edge: thanks to IT1 Bit (TCON Register) • If level triggering selection is set, the active level 0 or 1 can be selected with OELEV Bit (ISEL Register) The Bit IE1 (TCON Register) is set by hardware when external interrupt detected. It is cleared when interrupt is processed. Rxd Input A second vector interrupt input is the reception of a character. UART Rx input can gen- erate an interrupt if enabled with Bit RXEN (ISEL.0). The global enable bits EX1 and EA must also be set. Then, the Bit RXIT (ISEL Register) is set by hardware when a low level is detected on P3.0/RXD input. CPRES Input The third input is the detection of a level change on CPRES input (P1.2). This input can generate an interrupt if enabled with PRESEN (ISEL.1), EX1 (IE0.2) and EA (IE0.7) Bits. This detection is done according to the level selected with Bit CPLEV (ISEL.7). Then the Bit PRESIT (ISEL.5) is set by hardware when the triggering conditions are met. This Bit must be cleared by software. Interrupt Source Vector Address IE0 0003h TF0 000Bh IE1 & RxIt & PrIt 0013h TF1 001Bh RI & TI 0023h SCI 0053h |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |