M29DW128F datasheet(40/93 Pages) STMICROELECTRONICS

40 / 93 page

6 Command Interface

M29DW128F

40/93

Once the Password Protection mode is activated the device will permanently remain in this

mode.

6.3.9

Verify Password Protection Mode command

The Verify Password Protection Mode command reads the status of the Password Protection

Mode Lock Bit. If it is ‘1’, the device is in Password Protection mode.

6.3.10 Set Standard Protection Mode command

The Set Standard Protection Mode command puts the device in Standard Protection mode by

programming the Standard Protection Mode Lock bit to ‘1’.

Six cycles are required to issue the Standard Protection Mode command:

The first two cycles are unlock cycles.

The third cycle issues the program command.

The fourth and fifth cycles select the address (see Table 17: Protection Command

Addresses).

The last cycle verifies if the operation has been successful. If DQ0 is set to ’1’, the

Standard Protection Mode has been successfully activated. If DQ0 is ‘0’, the operation has

failed and the command must be re-issued.

There must be a 100µs delay between the fourth and fifth cycles.

Once the Standard Protection mode is activated the device will permanently remain in this

mode.

6.3.11 Verify Standard Protection Mode command

The Verify Standard Protection Mode command reads the status of the Standard Protection

Mode Lock Bit. If it is ‘1’, the device is in Standard Protection mode.

6.3.12 Set Non-Volatile Modify Protection Bit command

A block or group of blocks can be protected from program or erase by issuing a Set Non-Volatile

Modify Protection Bit command along with the block address. This command sets the Non-

Volatile Modify Protection bit to ‘1’ for a given block or group of blocks.

Six cycles are required to issue the command:

The first two cycles are unlock cycles.

The third cycle issues the program command.

The fourth and fifth cycles select the address (see Table 17: Protection Command

Addresses).

The last cycle verifies if the operation has been successful. If DQ0 is set to ’1’, the Non-

Volatile Modify Protection bit has been successfully programmed. If DQ0 is ‘0’, the

operation has failed and the command must be re-issued.

There must be a 100µs delay between the fourth and fifth cycles.

The Non-Volatile Modify Protection bits are erased simultaneously by issuing a Clear Non-

Volatile Modify Protection Bits command except if the Lock-Down bit is set to ‘1’.

The Non-Volatile Modify Protection bits can be set a maximum of 100 times.

M29DW128F Datasheet(PDF) 40 Page - STMicroelectronics

M29DW128F Datasheet(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93

Datasheet Download

Link URL