KMA310 datasheet(4/71 Pages) NXP

4 / 71 page

NXP Semiconductors

KMA310

Programmable angle sensor IC

KMA310

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 3 — 27 February 2019

4 / 71

6 Functional description

The KMA310 converts two orthogonal signals from MR sensor bridges into the digital

domain. The angle is calculated using the coordinate rotation digital computer (CORDIC)

algorithm. After a digital-to-analog conversion, the analog signal is provided to the output

as a linear representation of the angular value or transmitted in a SENT frame compliant

to SAE J2716. Zero angle, clamping voltages and angular range are programmable. In

addition, eight 12-bit registers are available for customer purposes, such as sample ID.

KMA310 comprises a cyclic redundancy check (CRC) and an error detection and

correction (EDC) to ensure a fail-safe operation. If either the supply voltage or the ground

line of the mixed signal IC is interrupted, a power-loss detection circuit pulls the output to

the remaining connection.

After conversion into the digital domain by an ADC, further processing is done within an

on-chip state machine. This state machine controls offset cancelation, calculation of the

mechanical angle using the CORDIC algorithm, as well as zero angle and angular range

adjustment. The internal digital-to-analog converter (DAC) and the analog output stage

are used for conversion of the angle information into an analog output voltage, which

is ratiometric to the supply voltage. Alternatively, the output signal can be transmitted

digitally in a SENT frame compliant to SAE J2716.

The configuration parameters are stored in a user-programmable non-volatile memory.

The OWI (accessible using pin OUT/DATA) is used for accessing the memory. In order to

protect the memory content a lock bit can be set. After locking the non-volatile memory,

its content cannot be changed anymore.

6.1 Angular measurement directions

The signals of the MR sensor bridges depend only on the direction of the external

magnetic field vector Hext, which is applied parallel to the plane of the sensor. In order to

obtain a correct output signal, exceed the minimum saturation field strength.

aaa-028142

Hext

Figure 2. Angular measurement directions

Since the anisotropic MR (AMR) effect is periodic over 180°, the sensor output is also

180°-periodic. The angle is calculated relative to a freely programmable zero angle. The

dashed line indicates the mechanical zero degree position.

KMA310 Datasheet(PDF) 4 Page - NXP Semiconductors