20

20

6.6 mOdule 6 - seTpOinT (alarm) parameTers ()

Setpoint

Annunciators

Output

Logic

Setpoint

Value

Power-up

State

Setpoint

Action

Setpoint

Assignment

Boundary

Type

Setpoint

Tracking

SPSEL

Setpoint

Select

PAR

6-SPt

Lit-n

SUP-n

ACt-n

ASN-n

SP-n

trC-n

tYP-n

Pro

OUt-n

tON-n

On Time

Delay

HYS-n

Setpoint

Hysteresis

Stb-n

Standby

Operation

PAR

tOFF-n

Off Time

Delay

Reset

w/SPn+1

Activates

AUtO-n

Counter

Auto Reset

tOUt-n

Time-out

Value

Reset

W/Display

Reset

rSd-n

rSAS-n

Reset

w/SPn+1

Deactivates

rSAE-n

PARAMETER MENU

Module 6 is the programming for the setpoint (alarms) output parameters. To have setpoint outputs, a setpoint option card needs to

be installed into the PAX (see Ordering Information). Depending on the card installed, there will be two or four setpoint outputs

available. For setpoint hardware and wiring details, refer to the bulletin shipped with the option card. For maximum input frequency,

unused Setpoints should be configured for  action.

The setpoint assignment and the setpoint action determine certain setpoint feature availability. The chart below illustrates this.

SETPOINT PARAMETER AVAILABILITY









SETPOINT SELECT

Select a setpoint (alarm output) to open the remaining module menu. (The

“” in the following parameters will reflect the chosen setpoint number.) After

the chosen setpoint is programmed, the display will default to  . Select

the next setpoint to be programmed and continue the sequence for each setpoint.

Pressing

PAR at   will exit Module 6.









SETPOINT ANNUNCIATORS



disables the display of the setpoint annunciator. Normal () displays

the corresponding setpoint annunciator of an “on” alarm output. Reverse ()

displays the corresponding setpoint annunciator of an “off” alarm output.



flashes the display and the corresponding setpoint annunciator of an

“on” alarm output.



























SETPOINT OUTPUT LOGIC

Normal () turns the output “on” when activated and “off” when

deactivated. Reverse () turns the output “off” when activated and “on” when

deactivated.









SETPOINT POWER UP STATE



will restore the output to the same state it was at before the meter was

powered down.  will activate the output at power up.  will deactivate the

output at power up.

































Yes

No

Yes

No

No

No

Reset When SPn+1 Deactivates

Yes

No

Yes

No

No

No

Reset When SPn+1 Activates

Yes

No

Yes

No

No

No

Reset With Display Reset

Yes

No

Yes

No

No

No

Counter Auto Reset

No

No

Yes

No

No

Yes

Setpoint Time Out

No

No

No

Yes

Yes

Yes

Setpoint On Delay

No

No

No

No

Yes

No

Setpoint Off Delay

No

No

No

No

Yes

No

Setpoint Hysteresis

No

Yes

No

Yes

Yes

Yes

Standby Operation

No

Yes

No

Yes

Yes

Yes

Boundary Type

Yes

Yes

Yes

Yes

Yes

Yes

Setpoint Tracking

Yes

Yes

Yes

Yes

Yes

Yes

Setpoint Value

Yes

Yes

Yes

Yes

Yes

Yes

Power Up State

Yes

Yes

Yes

Yes

Yes

Yes

Output Logic

Yes

Yes

Yes

Yes

Yes

Yes

Annunciators

LATCH



BOUNDARY



TIMED OUT



LATCH



BOUNDARY



TIMED OUT



COUNTER

RATE

DESCRIPTION









PARAMETER