Electrical Characteristics

MSC8113 Tri-Core Digital Signal Processor Data Sheet, Rev. 0

Freescale Semiconductor

23

Table 15. AC Timing for SIU Outputs

No.

Characteristic

Ref = CLKIN at 1.1 V

and 100/ 133 MHz

Units

Minimum delay from the 50% level of the REFCLK for all signals

0.9

ns

31

PSDVAL/TEA/TA max delay from the 50% level of the REFCLK rising edge

6.0

ns

32a

Address bus max delay from the 50% level of the REFCLK rising edge

•

Multi-master mode (SIUBCR[EBM] = 1)

•

Single-master mode (SIUBCR[EBM] = 0)

6.4

5.3

ns

ns

32b

Address attributes: TT[0–1]/TBST/TSZ/GBL max delay from the 50% level

of the REFCLK rising edge

6.4

ns

32c

Address attributes: TT[2–4]/TC max delay from the 50% level of the

REFCLK rising edge

6.9

ns

32d

BADDR max delay from the 50% level of the REFCLK rising edge

5.2

ns

33a

Data bus max delay from the 50% level of the REFCLK rising edge

•

Data-pipeline mode

•

Non-pipeline mode

4.8

7.1

ns

ns

33b

DP max delay from the 50% level of the REFCLK rising edge

•

Data-pipeline mode

•

Non-pipeline mode

6.0

7.5

ns

ns

34

Memory controller signals/ALE/CS[0–4] max delay from the 50% level of

the REFCLK rising edge

5.1

ns

35a

DBG/BG/BR/DBB max delay from the 50% level of the REFCLK rising

edge

6.0

ns

35b

AACK/ABB/TS/CS[5–7] max delay from the 50% level of the REFCLK

rising edge

5.5

ns

Notes:

1.

Values are measured from the 50% level of the REFCLK rising edge to the 50% signal level and assume a 20 pF load except

where otherwise specified.

2.

The load for specification 30 is 10 pF. The load for the other specifications in this table is 20 pF. For a 15 pF load, subtract 0.3

ns from the listed value.

3.

The maximum bus frequency depends on the mode:

• In 60x-compatible mode connected to another MSC8113 device, the frequency is determined by adding the input and output

longest timing values, which results in the total delay for 20 pF output capacitance. You must also account for other

influences that can affect timing, such as on-board clock skews, on-board noise delays, and so on.

• In single-master mode, the frequency depends on the timing of the devices connected to the MSC8113.

• To achieve maximum performance on the bus in single-master mode, disable the DBB signal by writing a 1 to the

SIUMCR[BDD] bit. See the SIU chapter in the MSC8113 Reference Manual for details.