CONEXTOP NEPORT User Manual
Chapter 3 Parameters
3-5
3.3.2 PPPoE Status
PPPoE status parameters are read-only, to display status of PPPoE dial-up connection.
parameter
contents
Link Status
Status of dial-up connection.
Option value: deactive/linking/active.
Default value: deactive.
PPPoE IP
IP address of dial-up connection.
PPPoE Gateway
Gateway of dial-up connection.
PPPoE DNS1
Preferred DNS address of dial-up connection.
PPPoE DNS2
Alternative DNS address of dial-up connection.
Table 3-7 PPPoE state
3.4 PPP
3.4.1 PPP
parameter
contents
User Name
User name of dial-up account
Option value: any string of length less than 31 bytes.
Default value: “admin”
Password
Password of dial-up account.
Option value: any string of length less than 21 bytes.
Default value: “admin”
Work Mode
Work mode of dial-up.
Option value:
Disable：
Disable the PPP dial-up function, the device can not
access network through PPP.
Auto Dial:
In such mode, the device will try to keep the dial-up
connection. Once the connection is disconnect, it will try
to connect again until connect success.
Dial on Demand:
When the device has to send data to network, but dial-up
connection is disconnected, it will dial up to connect.
Should use in cooperate with Idle Time.
Adaptive:
The device will use PPP dial-up connection or LAN to
transmit data automatically.
Default value: Disable.
New Zealand ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
