CONEXTOP NEPORT User Manual
Chapter 3 Parameters
3-11
Table 3-17 serial port settings
Caution:
Configuration at both ends of the serial line must be the same.
3.8.3 Pack Control
parameter
contents
Enable Packing
Whether or not to enable packing function. How to packing
serial data stream is dependant on the following parameters.
Option value: Enable/Disable
Default value: Disable
Idle Gap Time
Maximum time for inactivity. If there is any data on serial
port’s receive buffer, they will be packed and sent to network.
Option value(ms): 12/11/10
Default value: 12
Match 2 Byte Sequence
If enabled, used the two match bytes to indicate the beginning
and end of a series of data to be sent as one group. Otherwise,
used the first match byte to indicate the end of a series of data
to be sent as one group.
Option value: Enable/Disable.
Default value: Disable.
Send Frame Only
After the detection of the byte sequence, indicates whether to
send the data frame or the entire buffer.
Option value: YES/NO.
Default value: YES
Match Byte
Used to indicate the beginning and the end of a series of data to
be sent as one group.
Option value(HEX): 0x00-0xFF
Default value: 0x00
Table 3-18 serial packing settings
3.9 Connection
3.9.1 Connection Protocol
parameter
contents
Protocol
Network protocol
Option values: TCP/UDP
Default value: TCP
New Zealand ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
