CONEXTOP NEPORT User Manual
Chapter 3 Parameters
3-14
Table 3-25 TCP connection configuration
3.9.3.4 Disconnect Mode
parameter
contents
On DSR Drop
All TCP connection will be disconnect when serial’s DSR pin ‘s
voltage transfer from high to low.
Alternative value: Enable/Disable.
Default value: Disable.
Note: Only work on modem port.
Hard Disconnect
The TCP connection will closes even if the remote site does not
acknowledge the disconnect request.
Option value: Enable/Disable.
Default value: Disable.
Check EOT(Ctr-D)
Disconnect all connection when receive a character EOT(ctrl+D)
on the serial port.
Alternative value: Enable/Disable.
Default value: Disable；
Inactivity Timeout
When the TCP connection is idle (without any data transmission)
for a specified time, disconnect the connection automatically. If
the specified time is 0, disable this function.
Alternative values: 0-255.
Default value: 255.
Table 3-26 TCP disconnect mode
3.9.3.5 Flush Input Buffer
parameter
contents
With Active Connect
Whether or not to clear the input buffer of serial port when the
device initiative connect to the remote.
Option value: Enable/Disable.
Default value: Disable.
With Passive Connect
Whether or not to clear the input buffer of serial port when a
remote host initiative connect to the device.
Option value: Enable/Disable.
Default value: Disable.
At Time of Disconnect
Whether or not to clear the input buffer of serial port when the
connection of the device is disconnected.
Option value: Enable/Disable.
Default value: Disable.
Table 3-27 flush input buffer of serial port
New Zealand ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
