| Electronic Components Datasheet Search |
|
3G5A2-RPT01-PE Datasheet(PDF) 83 Page - Omron Electronics LLC |
|
|
|||||||||||||||||||||||||||||
3G5A2-RPT01-PE Datasheet(HTML) 83 Page - Omron Electronics LLC |
|
83 / 182 page ![]() ! 70 4-1 CPU Battery When the battery is nearly discharged, the ALARM indicator will blink, bit A42615 will turn ON, and the message “BATT LOW” will appear on the Program- ming Device. When this occurs, replace the battery within one week to avoid loss of data. The battery and connector are provided as a set. To replace the Battery Set, follow the steps below. The entire replacement must be completed within five minutes to ensure that the data will not be lost. Caution Do not short circuit, charge, disassemble, or expose the battery to heat. The bat- tery fluid is flammable and if mishandled, may cause a fire or explosion. Do not incinerate the battery after use. The expected life of the battery is 5 years for any CPU. The memory backup times are given in the following table. Model Backup time without power supplied Guaranteed value Effective value CV500 or CVM1-CPU01-EV2 9,000 hours (approx. 1 year) 43,000 hours (approx. 5 years) CV1000/CV2000/CVM1-CPU21-EV2 without Expansion DM or CVM1-CPU11-EV2 5,600 hours (approx. 0.6 year) CV1000/CV2000/CVM1-CPU21-EV2 with Expansion DM 2,900 hours (approx. 0.3 year) Guaranteed value: Memory backup time without power supplied at 55 °C. Effective value: Memory backup time without power supplied at 25 °C. Battery Replacement 1, 2, 3... 1. Turn on power to the PC for at least one minute. 2. Turn off power to the PC. (Although the battery can be replaced while power is being applied to the PC, it is not recommended, as short-circuiting is likely to occur.) 3. Remove the cover from the battery compartment. 4. Remove the old Battery Set. 5. Install the new Battery Set as shown below. Battery connector Battery holder Battery Set C500-BAT08 6. Replace the cover of the battery compartment. 7. When a Programming Console is mounted to the CPU after the battery has been replaced, “BATT LOW” will be displayed. This message can be cleared by pressing CLR, FUN, MONTR, or just turning the power to the PC OFF and ON again. CPU Battery Section 4-1 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |