AS4SD16M16 datasheet(10/52 Pages) MICROSS

10 / 52 page

SDRAM

AS4SD16M16

Rev. 2.6 04/13/15

Micross Components reserves the right to change products or specifications without notice.

READs

READ bursts are initiated with a READ command, as

shown in Figure 5.

The starting column and bank addresses are provided with

the READ command, and auto precharge is either enabled or

disabled for that burst access. If auto precharge is enabled,

the row being accessed is precharged at the completion of the

burst. For the generic READ commands used in the following

illustrations, auto precharge is disabled.

During READ bursts, the valid data-out element from the

starting column address will be available following the CAS

latency after the READ command. Each subsequent data-out

element will be valid by the next positive clock edge. Figure 6

shows general timing for each possible CAS latency setting.

Upon completion of a burst, assuming no other commands

have been initiated, the DQs will go High-Z. A full-page burst

will continue until terminated. (At the end of the page, it will

wrap to the start address and continue.)

Data from any READ burst may be truncated with a

subsequent READ command, and data from a fixed-length

READ burst may be immediately followed by data from a

READ

command. In either case, a continuous flow of data

can be maintained. The first data element from the new burst

follows either the last element of a complete burst or the last

desired data element of a longer burst that is being truncated.

The new READ command should be issued x cycles before

the clock edge at which the last desired data element is valid,

where x equals the CAS latency minus one. This is shown in

Figure 7 for CAS latencies of two and three; data element n+3

is either the last of a burst of four or the last desired of a longer

burst. The 256MB SDRAM uses a pipelined architecture and

therefore does not require the 2n rule associated with a prefetch

architecture. A READ command can be initiated on any clock

cycle following a previous READ command. Full-speed ran-

dom read accesses can be performed to the same bank, as shown

in Figure 8, or each subsequent READ may be performed to

different bank.

FIGURE 5: READ Command

FIGURE 6: CAS Latency

AS4SD16M16 Datasheet(PDF) 10 Page - Micross Components

AS4SD16M16 Datasheet(HTML) 10 Page - Micross Components

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Download

Link URL