MC908QT4MPE datasheet(93/184 Pages) FREESCALE

93 / 184 page

Oscillator Module Signals

MC68HC908QY/QT Family Data Sheet, Rev. 5

Freescale Semiconductor

11.3.4 RC Oscillator

The RC oscillator circuit is designed for use with an external resistor (REXT) to provide a clock source with

a tolerance within 25% of the expected frequency. See Figure 11-3.

The capacitor (C) for the RC oscillator is internal to the MCU. The REXT value must have a tolerance of

1% or less to minimize its effect on the frequency.

In this configuration, the OSC2 pin can be left in the reset state as PTA4. Or, the OSC2EN bit in the port

A pullup enable register can be set to enable the OSC2 output function on the pin. Enabling the OSC2

output slightly increases the external RC oscillator frequency, fRCCLK.

Figure 11-3. RC Oscillator External Connections

11.4 Oscillator Module Signals

The following paragraphs describe the signals that are inputs to and outputs from the oscillator module.

11.4.1 Crystal Amplifier Input Pin (OSC1)

The OSC1 pin is either an input to the crystal oscillator amplifier, an input to the RC oscillator circuit, or

an external clock source.

For the internal oscillator configuration, the OSC1 pin can assume other functions according to Table 1-3.

Function Priority in Shared Pins.

MCU

REXT

SIMOSCEN

OSC1

EXTERNAL RC

OSCILLATOR

RCCLK

÷ 2

BUSCLKX2

BUSCLKX4

TO SIM

FROM SIM

VDD

PTA4

I/O

PTA4

OSC2EN

PTA4/BUSCLKX4 (OSC2)

TO SIM

See Chapter 16 Electrical Specifications for component value requirements.

INTCLK

OSCRCOPT

MC908QT4MPE Datasheet(PDF) 93 Page - Freescale Semiconductor, Inc