MSC8103SLASHD datasheet(29/104 Pages) FREESCALE

29 / 104 page

CPM Ports

MSC8103 Network Digital Signal Processor, Rev. 11

Freescale Semiconductor

1-25

PC30

BRG2O

CLK2

Timer1: TOUT1

EXT1

Output

Input

Output

Input

Baud-Rate Generator 2 Output

The CPM supports up to 8 BRGs used internally by the bank-of-clocks

selection logic and/or to provide an output to one of the 8 BRG pins.

Clock 2

The CPM supports up to 10 clock input pins sent to the bank-of-clocks

selection logic, where they can be routed to the controllers.

Timer 1: Timer Out 1

The timers (Timer[1–4]) can output a signal on a timer output (TOUT[1–4])

when the reference value is reached. This signal can be an active-low

pulse or a toggle of the current output. The output can also connect

internally to the input of another timer, resulting in a 32-bit timer.

External Request 1

Asserts an internal request to the CPM processor. The signal can be

programmed as level- or edge-sensitive, and also has programmable

priority. Refer to the RISC Controller Configuration Register (RCCR)

description in the Chapter 17 of the

MSC8103 Reference Manual for

programming information. There are no current microcode applications for

this request line. It is reserved for future development.

PC29

BRG3O

CLK3

TIN2

SCC1: CTS, CLSN

Output

Input

Baud-Rate Generator 3 Output

The CPM supports up to 8 BRGs used internally by the bank-of-clocks

selection logic and/or to provide an output to one of the 8 BRG pins.

Clock 3

The CPM supports up to 10 clock input pins sent to the bank-of-clocks

selection logic, where they can be routed to the controllers.

Timer Input 2

A timer can have one of the following sources: another timer, system

clock, system clock divided by 16 or a timer input. The CPM supports up to

4 timer inputs. The timer inputs can be captured on the rising, falling or

both edges.

SCC1: Clear to Send, Collision

Typically used in conjunction with RTS. The MSC8103 SCC1 transmitter

sends out a request to send data signal (RTS). The request is accepted

when CTS is returned low. CLSN is the signal used in Ethernet mode. See

also PC15.

Table 1-9.

Port C Signals (Continued)

Name

Dedicated

I/O Data

Direction

Description

General-

Purpose I/O

Peripheral Controller:

Dedicated I/O

Protocol

MSC8103/D Datasheet(PDF) 29 Page - Freescale Semiconductor, Inc

MSC8103/D Datasheet(HTML) 29 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL