4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY & PREPARATION

Check to ensure that no damage has occurred during transit. Any damage

should be reported to your Clarke dealer immediately.

Using a clean, level area, unpack the equipment, laying out the loose items.

The motorcycle lift is packed flat in its lowest position. It is fully assembled,

except for ancillary items which are fitted as follows.

1. Attach the largest foot lever, (A),

to its square spigot on the base of

the unit, with the foot pedal

facing upwards and set at

approximately 10 o‘clock -

looking side on.

2. Attach the lowering pedal (B) in

the manner shown in Fig.2.

3. Attach the safety plate (C), using

the nuts, bolts and washers

provided. This plate is essential to

prevent accidental contact with

the lowering pedal which could

result in unexpected lowering of

the table.

4. Attach the two castors (D),

securing with the nuts bolts and

washers provided.

5. Attach the ramp (E) by dropping

the lugs into the holes in the table

and securing with the ‘R’ clips

provided.

6. CML3 - Pump the foot pedal very

gently to begin with, to ensure

that all parts are free. Continue to

pump the pedal and observe the

table rising. If any resistance is felt,

investigate to ensure that no part

is jammed by a loose or stray

ancillary component.