6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

NOTE: A 1HP (MIN) air compressor is recommended for operation,

although a 2HP compressor will increase the speed of operation.

FURTHER ASSEMBLY

When the pedal is assembled you may find that the foot plate is too near the

bottom of the safety plate. If so make these adjustments.

1. Raise the table and engage the safety locking bar as described on page 5

point 7.

2. When the table is secure, identify the adaptor, pin and ‘R’ clip as shown

above.

3. Remove the ‘R’ clip and pin and let the link bar drop down from between

the flanges of the adaptor.

4. Loosen the adaptor from the threaded pin by 2 - 3 threads.

5. Refit the link bar using the pin and ‘R’ clip’.

6. The foot plate should have lowered in relation to the pedal guard.

7. If the necessary foot plate position has not been reached, Repeat the

operation (Do not loosen the adaptor too much, make sure that sufficient

thread engages with the pin).

SYSTEM AIR PURGE

In the event of the platform not pumping up to full height it may be necessary

to purge air from the hydraulic system.

1. Pump up the platform as far as possible then fully lower using the lowering

pedal.