5

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

7. When the table is at its full height,

it should be possible to insert the

locking bar (F), through the hole in

the frame, (adjacent to the castor

mounting bracket), the

corresponding holes in each side

of the front lifting arm and out

through the opposite side of the

frame.

• The locking bar secures the

table to prevent any possibility

of it lowering while working,

and to provide a table working

platform.

8. Press the lowering lever (B) so that

the weight of the table is taken by

the locking bar.

9. Attach the front wheel clamps (G & H) and stop Plate (J) in the manner

shown in Fig.4.

10. Attach the lashing eyes (K), - one to each side as shown in Fig. 4. The lift is

now fully assembled.

CML3AIR

1. Using all safety precautions with

regard to using air equipment -

(REFER TO THE AIR COMPRESSOR

MANUAL), connect a suitable air

hose equipped with a snap on

type connector to the hand

controller shown in Fig. 5.

• The hand controller is located

on the end of the hose leading

to the hydraulic ram.

2. Start the compressor with the outlet pressure set to zero and then open the

outlet valve.

3. Set the output pressure to between 8 - 13 bar, depending upon the

compressor size.

4. Press down the operating lever of the hand controller. The ram will begin to

operate and the platform will rise. Be prepared to release the lever

immediately should any part of the lift become snagged.

5. Raise the platform to its maximum height, then proceed as described in

para. 7.