7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

2. Remove the filler plug to release

any trapped air, top up the

reservoir with clean hydraulic fluid

and re-insert the plug.

3. Repeat operations 1 and 2

(above) until all air is purged from

the system.

If the above procedure does not

cure the fault contact you local

Clarke dealer.

TO LOWER THE LIFT

As the weight of the table is taken by the Locking Bar, it is necessary to pump

the Foot Lever slightly in order to take the strain and then remove the Locking

Bar.

1. Visually check under and around the lift to ensure that no obstruction will

interfere when lowering the table.

2. Depress the lowering lever until the table is at its lowest position.

3. To manoeuvre the lift around the workshop, screw up the stabilizers to allow

the castors to function. For storage purposes, always screw the stabilizers

down to take the weight off the castors.