H8SLASH3021 datasheet(545/712 Pages) RENESAS

545 / 712 page

17. Power-Down State

Rev.2.00 Mar. 22, 2007 Page 521 of 684

REJ09B0352-0200

17.5

Hardware Standby Mode

17.5.1

Transition to Hardware Standby Mode

Regardless of its current state, the chip enters hardware standby mode whenever the

STBY pin

goes low. Hardware standby mode reduces power consumption drastically by halting all functions

of the CPU and on-chip supporting modules. All modules are reset except the on-chip RAM. As

long as the specified voltage is supplied, on-chip RAM data is retained. I/O ports are placed in the

high-impedance state.

Clear the RAME bit to 0 in SYSCR before

STBY goes low to retain on-chip RAM data.

The inputs at the mode pins (MD

2 to MD0) should not be changed during hardware standby mode.

17.5.2

Exit from Hardware Standby Mode

Hardware standby mode is exited by inputs at the

STBY and RES pins. While RES is low, when

STBY goes high, the clock oscillator starts running. RES should be held low long enough for the

clock oscillator to settle. When

RES goes high, reset exception handling begins, followed by a

transition to the program execution state.

17.5.3

Timing for Hardware Standby Mode

Figure 17.2 shows the timing relationships for hardware standby mode. To enter hardware standby

mode, first drive

RES low, then drive STBY low. To exit hardware standby mode, first drive

STBY high, wait for the clock to settle, then bring RES from low to high.

H8/3021 Datasheet(PDF) 545 Page - Renesas Technology Corp