AT89C51ED2-RDTUM datasheet(85/137 Pages) ATMEL

85 / 137 page

4235K–8051–05/08

AT89C51RD2/ED2

Table 19-2.

WDTPRG Register

WDTPRG - Watchdog Timer Out Register (0A7h)

Reset Value = XXXX X000

19.2

WDT during Power-down and Idle

In Power-down mode the oscillator stops, which means the WDT also stops. While in Power-

down mode the user does not need to service the WDT. There are 2 methods of exiting Power-

down mode: by a hardware reset or via a level activated external interrupt which is enabled prior

to entering Power-down mode. When Power-down is exited with hardware reset, servicing the

WDT should occur as it normally should whenever the AT89C51RD2/ED2 is reset. Exiting

Power-down with an interrupt is significantly different. The interrupt is held low long enough for

the oscillator to stabilize. When the interrupt is brought high, the interrupt is serviced. To prevent

the WDT from resetting the device while the interrupt pin is held low, the WDT is not started until

the interrupt is pulled high. It is suggested that the WDT be reset during the interrupt service

routine.

To ensure that the WDT does not overflow within a few states of exiting of powerdown, it is bet-

ter to reset the WDT just before entering powerdown.

In the Idle mode, the oscillator continues to run. To prevent the WDT from resetting the

AT89C51RD2/ED2 while in Idle mode, the user should always set up a timer that will periodically

exit Idle, service the WDT, and re-enter Idle mode.

Bit

Number

Bit

Mnemonic

Description

Reserved

The value read from this bit is undetermined. Do not try to set this bit.

WDT Time-out select bit 2

WDT Time-out select bit 1

WDT Time-out select bit 0

S1 S0Selected Time-out

(214 - 1) machine cycles, 16. 3 ms @ F

OSCA =12 MHz

(215 - 1) machine cycles, 32.7 ms @ FOSCA=12 MHz

10 (216 - 1) machine cycles, 65. 5 ms @ F

OSCA=12 MHz

(217 - 1) machine cycles, 131 ms @ F

OSCA=12 MHz

(218 - 1) machine cycles, 262 ms @ FOSCA=12 MHz

01 (219 - 1) machine cycles, 542 ms @ F

OSCA=12 MHz

(220 - 1) machine cycles, 1.05 ms @ F

OSCA=12 MHz

(221 - 1) machine cycles, 2.09 ms @ FOSCA=12 MHz

AT89C51ED2-RDTUM Datasheet(PDF) 85 Page - ATMEL Corporation

AT89C51ED2-RDTUM Datasheet(HTML) 85 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL