PIC12F519-ESLASHMS datasheet(72/96 Pages) MICROCHIP

72 / 96 page

PIC12F519

DS41319B-page 70

TABLE 11-7:

TIMING REQUIREMENTS

FIGURE 11-6:

RESET, WATCHDOG TIMER AND DEVICE RESET TIMER TIMING

AC CHARACTERISTICS

Standard Operating Conditions (unless otherwise specified)

Operating Temperature

-40

°C ≤ TA ≤ +85°C (industrial)

-40

°C ≤ TA ≤ +125°C (extended)

Operating Voltage VDD range is described in

Param

No.

Sym.

Characteristic

Min.

Typ(1)

Max.

Units

TOSH2IOVOSC1

↑ (Q1 cycle) to Port Out Valid(2), (3)

—

100*

TOSH2IOIOSC1

↑ (Q2 cycle) to Port Input Invalid (I/O in hold

time)(2)

—

TIOV2OSH

Port Input Valid to OSC1

↑ (I/O in setup time)

—

TIOR

Port Output Rise Time(3)

—

50**

TIOF

Port Output Fall Time(3)

—

50**

TBD = To be determined.

* These parameters are characterized but not tested.

** These parameters are design targets and are not tested.

Note 1:

Data in the Typical (“Typ”) column is at 5V, 25°C unless otherwise stated. These parameters are for design

guidance only and are not tested.

Measurements are taken in EXTRC mode.

See Figure 11-3 for loading conditions.

VDD

MCLR

Internal

POR

DRT

Time-out(2)

Internal

Reset

Watchdog

Timer

Reset

I/O pin(1)

Note

I/O pins must be taken out of High-Impedance mode by enabling the output drivers in software.

Runs in MCLR or WDT Reset only in XT and LP.

PIC12F519-E/MS Datasheet(PDF) 72 Page - Microchip Technology

PIC12F519-E/MS Datasheet(HTML) 72 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96

Datasheet Download

Link URL