PIC16F87X datasheet(93/218 Pages) MICROCHIP

93 / 218 page

 1998-2013 Microchip Technology Inc.

DS30292D-page 93

PIC16F87X

9.2.18.3

Bus Collision During a STOP

Condition

Bus collision occurs during a STOP condition if:

After the SDA pin has been de-asserted and

allowed to float high, SDA is sampled low after

the BRG has timed out.

After the SCL pin is de-asserted, SCL is sam-

pled low before SDA goes high.

The STOP condition begins with SDA asserted low.

When SDA is sampled low, the SCL pin is allowed to

float. When the pin is sampled high (clock arbitration),

the baud rate generator is loaded with SSPADD<6:0>

and counts down to 0. After the BRG times out, SDA is

sampled. If SDA is sampled low, a bus collision has

occurred. This is due to another master attempting to

drive a data '0'. If the SCL pin is sampled low before

SDA is allowed to float high, a bus collision occurs. This

is a case of another master attempting to drive a data

'0' (Figure 9-25).

FIGURE 9-25:

BUS COLLISION DURING A STOP CONDITION (CASE 1)

FIGURE 9-26:

BUS COLLISION DURING A STOP CONDITION (CASE 2)

SDA

SCL

BCLIF

PEN

SSPIF

TBRG

SDA asserted low

SDA sampled

low after TBRG,

Set BCLIF

'0'

SDA

SCL

BCLIF

PEN

SSPIF

TBRG

Assert SDA

SCL goes low before SDA goes high,

Set BCLIF

'0'

PIC16F87X Datasheet(PDF) 93 Page - Microchip Technology

PIC16F87X Datasheet(HTML) 93 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL