THS8083APZP datasheet(45/64 Pages) TI

45 / 64 page

5–1

5 Electrical Specifications

Electrical specifications over recommended operating conditions with Fs = 80 MSPS (unless otherwise noted)

5.1

Definition of Test Conditions

3.6

µs

800 mVPP

1/60 kHz = 16.6

µs

Figure 5–1. Input Test Waveform

Test condition SYSTEM_INTREF refers to:

•

All supplies at 3.3 V

•

XTL1_MCLK & XTL2 connected at 14.31818 MHz

•

No power downs enabled

•

XGA at 75-Hz operation mode, internal clock, clamping enabled, internal clamp timing, coarse and fine

PGAs at midscale, bottom-level clamping, clamp code at midscale, 24-bit output mode

•

Identical ac-coupled 0.8 Vpp ramp-shape input on all 3 channels at 60.0-kHz line rate, as shown in

Figure 5–1

•

Use of internal bandgap and voltage references

Test condition PLL refers to:

•

SYSTEM_INTREF, with an input signal other than the ramp-shape input test waveform of Figure 5–1.

Test condition ADC_INTREF refers to:

•

All supplies at 3.3 V

•

Use of internal bandgap and voltage references

•

Use of external ADCCLK clock (SEL_ADCCLK = 1), driven at 81.92 MHz

•

No power downs enabled

•

Identical ac-coupled, 0.8 Vpp ramp-shape input on all three channels at 60.0-kHz line rate, as shown in

Figure 5–1

Test condition ADC_EXTREF refers to:

•

ADC_INTREF, except: PWDN_BGAP = PWDN_REF = 1, VMID and VREFTO/BO driven from an external

source at nominal levels

Test condition ADC_PWDN refers to:

•

ADC_INTREF, except: PWDN_ALL = 1

THS8083APZP Datasheet(PDF) 45 Page - Texas Instruments

THS8083APZP Datasheet(HTML) 45 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Download

Link URL