OR3C55-5BA352I datasheet(82/210 Pages) AGERE

82 / 210 page

Lucent Technologies Inc.

Data Sheet

June 1999

ORCA Series 3C and 3T FPGAs

Programmable Clock Manager (PCM) (continued)

Table 31. PCM Control Registers (continued)

Bit #

Function

Bits [5:4]

ExpressCLK

Output Source Selector. Default is 00.

00: PCM input clock, bypass path through PCM

01: DLL output

10: tapped delay line output

11: divided (DIV2) delay line output

Bits [7:6]

System Clock Output Source Selector. Default is 00.

00: PCM input clock, bypass path through PCM

01: DLL output

10: tapped delay line output

11: reserved

Bit 0

PCM Analog Power Supply Switch. 1 = power supply on, 0 = power supply off.

Bit 1

PCM Reset. A value of 1 resets all PCM logic for PLL and DLL modes.

Bit 2

DLL Reset. A value of 1 resets the clock generation logic for DLL mode. No dividers or user reg-

isters are affected.

Bits [5:3]

Reserved.

Bit 6

PCM Configuration Operation Enable Bit. 0 = normal configuration operation. During configu-

ration (DONE = 0), the PCM analog power supply will be off, the PCM output data bus is 3-stated,

and the LOCK signal is asserted to logic 0. The PCM will power up when DONE = 1.

1 = PCM operation during configuration. The PCM may be powered up (see bit 0) and begin

operation, or continue operation. The setup of the PCM can be performed via the configuration

bit stream.

Bit 7

PCM GSRN Enable Bit. 0 = normal GSRN operation. 1 = GSRN has no effect on PCM logic, so

clock processing will not be interrupted by a chip reset. Default is 0.

OR3C55-5BA352I Datasheet(PDF) 82 Page - Agere Systems