ISL8200AMM

FN8287 Rev 2.00

Page 7 of 24

June 3, 2015

Absolute Maximum Ratings

Thermal Information

Input Voltage, PVIN, VIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +27V

Driver Bias Voltage, PVCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +6.0V

Signal Bias Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +6.5V

BOOT/UGATE Voltage, VBOOT . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +36V

Phase Voltage, VPHASE . . . . . . . . . . . . . . . . . . . VBOOT - 7V to VBOOT + 0.3V

BOOT to PHASE Voltage,

VBOOT - VPHASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC + 0.3V

Input, Output or I/O Voltage . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC + 0.3V

ESD Rating

Human Body Model (Tested per JESD22-A114E) . . . . . . . . . . . . . . . . 2kV

Machine Model (Tested per JESD22-A115-A) . . . . . . . . . . . . . . . . . 200V

Charge Device Model (Tested per JESD22-C101C). . . . . . . . . . . . . . . 1kV

Latch-up (Tested per JESD-78B; Class 2, Level A) . . . . . . . . . . . . . . 100mA

Thermal Resistance (Typical)

JA (°C/W) JC (°C/W)

QFN Package (Notes 3, 4) . . . . . . . . . . . . . .

13

2.0

Maximum Storage Temperature Range . . . . . . . . . . . . . .-55°C to +150°C

Recommended Operating Conditions

Input Voltage, PVIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3V to 20V

Input Bias Voltage, VIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 20V

Driver Bias Voltage, PVCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.6V

Signal Bias Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.6V

Boot to Phase Voltage

VBOOT - VPHASE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <6V

Ambient Temperature Range . . . . . . . . . . . . . . . . . . . . . . .-55°C to +125°C

Junction Temperature Range . . . . . . . . . . . . . . . . . . . . . . .-55°C to +125°C

CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product

reliability and result in failures not covered by warranty.

NOTES:

3.

JA is measured in free air with the component mounted on a high effective thermal conductivity test board (i.e., 4-layer type without thermal vias -

see tech brief TB379) per JEDEC standards except that the top and bottom layers assume solid plains.

4. For

JC, the “case temp” location is the center of the exposed metal pad on the package underside.

Electrical Specifications Boldface limits apply across the operating temperature range, -55°C to +125°C.

PARAMETER

SYMBOL

TEST CONDITIONS

MIN

(Note 6)

TYP

(Note 5)

MAX

(Note 6)

UNIT

VCC SUPPLY CURRENT

Nominal Supply VIN Current

IQ_VIN

PVIN = VIN = 20V; No Load; fSW = 700kHz

36

mA

Nominal Supply VIN Current

IQ_VIN

PVIN = VIN = 4.5V; No Load; fSW = 700kHz

27

mA

Shutdown Supply VCC Current

IVCC

EN = 0V, VCC = 2.97V

9

mA

INTERNAL LINEAR REGULATOR

Maximum Current

IPVCC

PVCC = 4V to 5.6V

320

mA

Saturated Equivalent Impedance

RLDO

P-Channel MOSFET (VIN = 5V)

1

Ω

POWER-ON RESET

Rising VCC Threshold

2.85

(Note 7)

V

Falling VCC Threshold

2.65

(Note 7)

V

Rising PVCC Threshold

2.85

(Note 7)

V

Falling PVCC Threshold

2.65

(Note 7)

V

System Soft-start Delay

tSS_DLY

After PLL, VCC, and PVCC PORs, and EN above

their thresholds

384

Cycles

ENABLE

Turn-On Threshold Voltage

(Note 7)

0.8

(Note 7)

V

Hysteresis Sink Current

IEN_HYS

(Note 7)

30

(Note 7)

µA

Undervoltage Lockout Hysteresis

VEN_HYS

VEN_RTH = 10.6V; VEN_FTH = 9V

RUP = 53.6kΩ, RDOWN = 5.23kΩ

1.6

V

Sink Current

IEN_SINK

VEN = 1V

(Note 7)

mA

Sink Impedance

REN_SINK

VEN = 1V

(Note 7)

Ω

OSCILLATOR

Oscillator Frequency

FOSC

RFS = 59kΩFigure 34

700

kHz

Total Variation

VCC = 5V;

(Note 7)

(Note 7)

%

FREQUENCY SYNCHRONIZATION AND PHASE LOCK LOOP (Note 7)

Synchronization Frequency

VCC = 5.4V

FOSC

(Note 7)

kHz