H8SLASH3003 datasheet(215/715 Pages) RENESAS

215 / 715 page

Normal Mode

•

Auto-request

The DMAC is activated by register setup alone, and continues executing transfers until the

designated number of transfers have been completed. A CPU interrupt can be requested at

completion of the transfers. Both addresses are 24-bit addresses.

— Cycle-steal mode

The bus is released to another bus master after each byte or word is transferred.

— Burst mode

Unless requested by a higher-priority bus master, the bus is not released until the

designated number of transfers have been completed.

•

External request

One byte or word is transferred per request. A designated number of these transfers are

executed. A CPU interrupt can be requested at completion of the designated number of

transfers. Both addresses are 24-bit addresses.

Block Transfer Mode: One block of a specified size is transferred per request. A designated

number of block transfers are executed. At the end of each block transfer, one address is restored

to its initial value. When the designated number of blocks have been transferred, a CPU interrupt

can be requested. Both addresses are 24-bit addresses.

197

H8/3003 Datasheet(PDF) 215 Page - Renesas Technology Corp