NAND01G-B2C datasheet(27/67 Pages) NUMONYX

27 / 67 page

NAND01G-B2C

Device operations

27/67

6.3.2

Random data input in a page

During a sequential input operation, the next sequential address to be programmed can be

replaced by a random address, by issuing a Random Data Input command. The following

two steps are required to issue the command:

one bus cycle is required to setup the Random Data Input command (see Table 10)

two bus cycles are then required to input the new column address (refer to Table 6).

Random Data Input can be repeated as often as required in any given page.

Once the program operation has started the status register can be read using the Read

Status Register command. During program operations the status register will only flag errors

for bits set to '1' that have not been successfully programmed to '0'.

During the program operation, only the Read Status Register and Reset commands will be

accepted, all other commands will be ignored.

Once the program operation has completed the P/E/R controller bit SR6 is set to ‘1’ and the

Ready/Busy signal goes High.

The device remains in read status register mode until another valid command is written to

the command interface.

Figure 11.

Page program operation

I/O

Address Inputs

SR0

ai08659

Data Input

10h

70h

80h

Page Program

Setup Code

Confirm

Code

Read Status Register

Busy

tBLBH2

(Program Busy time)

NAND01G-B2C Datasheet(PDF) 27 Page - Numonyx B.V