SL2S3003FUD datasheet(61/82 Pages) NXP

61 / 82 page

NXP Semiconductors

SL2S3003/SL2S3003TT

ICODE 3 (TagTamper)

8.5.3.19 STAY QUIET PERSISTENT

Command code = BCh

When receiving the STAY QUIET PERSISTENT command, the label IC enters the persistent quiet state and

does not send back a response.

Note: The STAY QUIET PERSISTENT command has the same behavior as the mandatory STAY QUIET

command. The only difference is at reset (power off). If the power off time exceeds the persistent time, the label

IC switches to the ready state,.

When in PERSISTENT QUIET state:

• The label IC does not process any request where the Inventory_flag is set, except:

– If the AFI_flag is set, or

– If the QUIET and PERSTENT QUIET flags in the extended mode of the (Fast) Inventory command are both

set.

• The label IC processes any EAS ALARM request, and any addressed or selected request.

The label IC exits the persistent quiet state when:

• Reset (power off) exceeds the persistent time.

• Receiving a SELECT request. The IC goes to the Selected state.

• Receiving a RESET TO READY request. The IC goes to the Ready state.

The STAY QUIET PERSISTENT command must be executed in addressed mode (Select_flag is set to 0 and

Address_flag is set to 1).

SOF

Flags

STAY QUIET PER

SISTENT

IC Mfg code

UID

CRC16

EOF

8 bits

64 bits optional 16 bits

Table 114. STAY PERSISTENT QUIET request format

SL2S3003/SL2S3003TT

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 3.0 — 28 March 2024

61 / 82

SL2S3003FUD Datasheet(PDF) 61 Page - NXP Semiconductors