7643 datasheet(97/121 Pages) RENESAS

97 / 121 page

Rev.2.00

Aug 28, 2006

page 97 of 119

7643 Group

REJ03B0054-0200

(2) Parallel I/O Mode

Parallel I/O mode is the mode which parallel output and input soft-

ware command, address, and data required for the operations

(read, program, erase, etc.) to a built-in flash memory. Use the ex-

clusive external equipment flash programmer which supports the

7643 Group (flash memory version). Refer to each programmer

maker’s handling manual for the details of the usage.

User ROM and Boot ROM Areas

In parallel I/O mode, the user ROM and boot ROM areas shown in Fig-

ure 88 can be rewritten. Both areas of flash memory can be operated on

in the same way.

Program and block erase operations can be performed in the user ROM

area. The user ROM area and its block is shown in Figure 78.

The boot ROM area is 4 Kbytes in size. It is located at addresses

F00016 through FFFF16. Make sure program and block erase opera-

tions are always performed within this address range. (Access to any

location outside this address range is prohibited.)

In the Boot ROM area, an erase block operation is applied to only

one 4 Kbyte block. The boot ROM area has had a standard serial I/O

mode control program stored in it when shipped from the Renesas

factory. Therefore, using the device in standard serial I/O mode, you

do not need to write to the boot ROM area.

7643 Datasheet(PDF) 97 Page - Renesas Technology Corp