H8SLASH3003 datasheet(105/715 Pages) RENESAS

105 / 715 page

5.3 Interrupt Sources

The interrupt sources include external interrupts (NMI, IRQ0 to IRQ7) and 34 internal interrupts.

5.3.1 External Interrupts

There are nine external interrupts: NMI, and IRQ0 to IRQ7. Of these, NMI, IRQ0, IRQ1, and IRQ2

can be used to exit software standby mode.

NMI: NMI is the highest-priority interrupt and is always accepted, regardless of the states of the

I and UI bits in CCR. The NMIEG bit in SYSCR selects whether an interrupt is requested by the

rising or falling edge of the input at the NMI pin. NMI interrupt exception handling has vector

number 7.

IRQ0 to IRQ7 Interrupts: These interrupts are requested by input signals at pins IRQ0 to IRQ7.

The IRQ0 to IRQ7 interrupts have the following features.

•

ISCR settings can select whether an interrupt is requested by the low level of the input at pins

IRQ0 to IRQ7, or by the falling edge.

•

IER settings can enable or disable the IRQ0 to IRQ7 interrupts. Interrupt priority levels can be

assigned by four bits in IPRA (IPRA7 to IPRA4).

•

The status of IRQ0 to IRQ7 interrupt requests is indicated in ISR. The ISR flags can be

cleared to 0 by software.

Figure 5-2 shows a block diagram of interrupts IRQ0 to IRQ7.

Figure 5-2 Block Diagram of Interrupts IRQ0 to IRQ7

input

Edge/level

sense circuit

IRQnSC

IRQnF

IRQnE

IRQn interrupt

request

Clear signal

IRQn

Note: n = 7 to 0

H8/3003 Datasheet(PDF) 105 Page - Renesas Technology Corp