MC9S08DN60F1CLF datasheet(111/356 Pages) FREESCALE

111 / 356 page

Chapter 7 Central Processor Unit (S08CPUV3)

MC9S08DN60 Series Data Sheet, Rev 3

Freescale Semiconductor

111

7.2.3

Stack Pointer (SP)

This 16-bit address pointer register points at the next available location on the automatic last-in-ﬁrst-out

(LIFO) stack. The stack may be located anywhere in the 64-Kbyte address space that has RAM and can

be any size up to the amount of available RAM. The stack is used to automatically save the return address

for subroutine calls, the return address and CPU registers during interrupts, and for local variables. The

AIS (add immediate to stack pointer) instruction adds an 8-bit signed immediate value to SP. This is most

often used to allocate or deallocate space for local variables on the stack.

SP is forced to 0x00FF at reset for compatibility with the earlier M68HC05 Family. HCS08 programs

normally change the value in SP to the address of the last location (highest address) in on-chip RAM

during reset initialization to free up direct page RAM (from the end of the on-chip registers to 0x00FF).

The RSP (reset stack pointer) instruction was included for compatibility with the M68HC05 Family and

is seldom used in new HCS08 programs because it only affects the low-order half of the stack pointer.

7.2.4

Program Counter (PC)

The program counter is a 16-bit register that contains the address of the next instruction or operand to be

fetched.

During normal program execution, the program counter automatically increments to the next sequential

memory location every time an instruction or operand is fetched. Jump, branch, interrupt, and return

operations load the program counter with an address other than that of the next sequential location. This

is called a change-of-ﬂow.

During reset, the program counter is loaded with the reset vector that is located at 0xFFFE and 0xFFFF.

The vector stored there is the address of the ﬁrst instruction that will be executed after exiting the reset

state.

7.2.5

Condition Code Register (CCR)

The 8-bit condition code register contains the interrupt mask (I) and ﬁve ﬂags that indicate the results of

the instruction just executed. Bits 6 and 5 are set permanently to 1. The following paragraphs describe the

functions of the condition code bits in general terms. For a more detailed explanation of how each

instruction sets the CCR bits, refer to the HCS08 Family Reference Manual, volume 1, Freescale

Semiconductor document order number HCS08RMv1.

MC9S08DN60F1CLF Datasheet(PDF) 111 Page - Freescale Semiconductor, Inc