EVALAD5933EB datasheet(14/32 Pages) AD

14 / 32 page

EVAL-AD5933EB

Preliminary Technical Data

Rev. PrC | Page 14 of 32

EXPAND ROOT

DIRECTORY

Figure 21. Correctly Installed Hardware

When I plug in my board for the first time during the

installation process, the message shown in Figure 22 appears.

Then, when I click Finish, the message shown in Figure 23

appears. What should I do next?

Figure 22. Error During the Hardware Installation

Figure 23. Error During the Hardware Installation

The computer has not recognized the USB device, that is, the

AD5933 evaluation board that is plugged in. Assuming that the

evaluation software is installed correctly (you should have installed

the software correctly prior to plugging in the board for the first

time), this message simply indicates that the AD5933 device

drivers have not been installed to the correct registry and

therefore cannot be correctly located by the install wizard.

To reinstall the device drivers, right-click My Computer and

then left-click Properties. On the Hardware tab, choose Device

Manager

. Expand Other devices (see Figure 24). Right-click

USB Device

and then left-click Uninstall Driver. Unplug the

evaluation board and wait approximately 30 seconds before

plugging it in again. Proceed through the installation wizard a

second time. A correct installation should be indicated by the

expanded root directory in Figure 25.

If you encounter the same error message, uninstall both the

device driver and the software and Contact the Analog Devices

Technical Support Center for further instructions regarding

valid driver files.

1: EXPAND THIS

EVALAD5933EB Datasheet(PDF) 14 Page - Analog Devices